Printing problem

[David Squance]

I see.  I guess I wasn't clear enough before.  There's no cycling.  It just
prints the card (there's only one in the stack) after hiding what I don't
want to print.  Also nothing is waiting to happen after the print, so I
can't see how timing could be an issue.  Do you think there should be some
sort of wait command before the script ends?
Thanks, anyhow.
Dave

>I assume to get the contents you must go through each field??? if not
>then there is not loop.
>
>Timing after a print command is what I meant. It is always best to
>allow time for these things to complete.
>
>Tom
>
>
>>  I'm trying to print
>> the content of a couple dozen fields in a sort of contrived array with
>> a
>> simple "print this card" statement in a button
>On Feb 25, 2004, at 8:07 PM, David Squance wrote:
>
>>> You probably have a timing issue that you are not allowing enough time
>>> in your loop for rev to put the item to be printed to collect and then
>>> send to your printer.
>>>
>>> Check out your loop and with messages etc.
>>>
>> Thanks for the reply.  I don't understand it, however.  What loop?  The
>> script masks the buttons, turns off the borders, prints the card,
>> turns on
>> the borders and that's it.  And what does "and with messages" mean?  I
>> had
>> a look at the message watcher while it crashed, and there was nothing
>> there
>> that gave any clues.
>> Dave
>>
>>
>> _______________________________________________
>> use-revolution mailing list
>> use-revolution at lists.runrev.com
>> http://lists.runrev.com/mailman/listinfo/use-revolution
>>
>>
>
>Thomas J. McGrath III
>SCS
>1000 Killarney Dr.
>Pittsburgh, PA 15234
>412-885-8541
>
>_______________________________________________
>use-revolution mailing list
>use-revolution at lists.runrev.com
>http://lists.runrev.com/mailman/listinfo/use-revolution